Installing a Roll-N-Lock bed cover on your truck provides security and weather protection for your cargo. Roll-N-Lock covers are typically designed for specific truck models, so ensure you have the correct cover for your truck’s make and model. Here’s a general guide on how to install a Roll-N-Lock bed cover:
Materials You’ll Need:
- Roll-N-Lock bed cover kit (specific to your truck model)
- Wrenches or socket set
- Screwdriver
- Measuring tape
- Level
- Utility knife
- Silicone sealant (optional)
Steps:
- Prepare the Truck Bed:
- Clean the truck bed thoroughly to ensure there is no debris or dirt. A clean surface will help with proper installation.
- Unbox and Inspect the Kit:
- Open the Roll-N-Lock kit and inspect its contents. Ensure all parts and components are included and in good condition.
- Position the Rails:
- Start with the side rails. Position one side rail on each side of the truck bed, making sure they are aligned parallel to the bed walls. Use a level to check for alignment.
- Measure for Placement:
- Measure the distance from the front of the bed to ensure the side rails are spaced correctly according to the manufacturer’s instructions. Typically, there should be a specified gap.
- Secure the Rails:
- Attach the side rails to the truck bed using the provided clamps and fasteners. Tighten them securely using a wrench or socket set.
- Install the Canister:
- Depending on your Roll-N-Lock model, there may be a canister that houses the cover. Install this canister according to the manufacturer’s instructions. It usually attaches to the front of the bed near the bulkhead.
- Mount the Cover:
- Carefully unroll the cover from the canister and align it with the side rails. Ensure that it is centered and properly seated.
- Secure the Cover:
- Secure the cover to the side rails using the provided clamps or fasteners. Make sure it is evenly tensioned and rolls smoothly.
- Check for Proper Alignment:
- Carefully open and close the cover to check for proper alignment and smooth operation. Make any necessary adjustments to ensure it rolls correctly.
- Optional Sealant (if needed):
- If your kit includes sealing strips or if you want to improve weather resistance, you can apply silicone sealant along the edges where the cover meets the side rails. Allow it to dry as per the manufacturer’s recommendations.
- Test the Locking Mechanism:
- Ensure that the locking mechanism functions correctly to secure the cover in place when closed.
- Test for Leaks (if sealed):
- If you applied sealant, run a water test to check for any leaks. Use a hose to spray water on the cover and check inside the bed for any signs of water infiltration.
- Final Adjustments:
- Make any final adjustments as needed to ensure that the cover operates smoothly and provides a secure seal.
Installing a Roll-N-Lock bed cover can vary depending on the specific model and truck type. Always follow the manufacturer’s instructions provided with your kit, as there may be model-specific variations in the installation process. If you’re not comfortable with the installation, consider seeking professional assistance to ensure a proper and secure installation.
Also Read:
https://infusionpost.com/how-to-install-press-in-grease-fittings/
https://infusionpost.com/how-to-install-racing-harness-without-bar/
https://infusionpost.com/how-to-install-range-hood-on-vaulted-ceiling/
https://infusionpost.com/how-to-install-retrofit-windows/
